Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014EDGE SE, 4D UTILITY, 2.0L ENG VIN 9REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALOEM CONNECTOR END VIEWSFRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) CONNECTOR END VIEW (C2123)
2014 Ford Edge SE, 4D Utility, 2.0L Eng VIN 9
Front Control/Display Interface Module (FCDIM) Connector End View (C2123)
2014 Ford Edge SE, 4D Utility, 2.0L Eng VIN 9SECTION Front Control/Display Interface Module (FCDIM) Connector End View (C2123)
| Pin | Circuit | Gauge | Circuit Function | Qualifier |
|---|---|---|---|---|
| 1 | SBP29 (GY-RD) | 22 | FUSE - 29 OR CIRCUIT BREAKER | |
| 2 | * | * | Not Used | |
| 3 | * | * | Not Used | |
| 4 | VDB13 (BU-GY) | 22 | INSTRUMENT CLUSTER # CAN BUS MULTIMEDIA HIGH | |
| 5 | VDB14 (VT-GY) | 22 | INSTRUMENT CLUSTER # CAN BUS MULTIMEDIA LOW | |
| 6 | VMP19 (WH-GN) | 22 | CAMERA - PARKING AID REAR VIDEO | with rear view camera |
| 7 | * | * | Not Used | |
| 8 | * | * | Not Used | |
| 9 | GD115 (BK-GY) | 20 | GROUND - CROSS CAR BEAM # 2ND POINT | |
| 10 | * | * | Not Used | |
| 11 | * | * | Not Used | |
| 12 | RMP19 (BN-VT) | 22 | CAMERA - PARKING AID REAR VIDEO - | with rear view camera |
| Available Pigtail Kits | |
|---|---|
| Pigtail Kit Part Number WPT-1278 | Service Part Number: CU2Z-14S411-ABA Gauge: 18 Pin material: Tin (greased) Cavities: 12 Vehicle Uses
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.