Brake Pedal Position (BPP) Switch Connector End View (C2064)

2014 Ford Edge SE, 4D Utility, 2.0L Eng VIN 9SECTION Brake Pedal Position (BPP) Switch Connector End View (C2064)
Fig 1: Identifying Brake Pedal Position Switch Connector (C2064)
G09229789Courtesy of FORD MOTOR CO.
Pin Circuit Gauge Circuit Function Qualifier
1 SBB59 (BU-RD) 22 FUSE - 59 OR CIRCUIT BREAKER  
2 CES09 (VT-OG) 20 SWITCH - BRAKE PEDAL # SPEED CONTROL DEACTIVATION (BPS)  
3 GD120 (BK-GN) 20 GROUND - FENDER FRONT LEFT 3.5L/3.7L TIVCT
3 GD124 (BK-VT) 20 GROUND - FENDER FRONT RIGHT # 2ND POINT 2.0L GTDI
4 CCB08 (VT-WH) 20 SWITCH - BRAKE PEDAL POSITION (BPP) NORMAL OPEN  
4 CCB08 (VT-WH) 22 SWITCH - BRAKE PEDAL POSITION (BPP) NORMAL OPEN  
Available Pigtail Kits  
Pigtail Kit Part Number WPT-912 
G09229790
Service Part Number: 8U2Z-14S411-HA 
Gauge: 14 
Pin material: Tin 
Cavities:
Vehicle Uses
  • Sensor - Oil Temperature
  • Sensor - Power Steering Pressure
  • Sensor - Purge Flow
  • Switch - Gear Shift Select/Neutral Safety
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.