Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014EDGE SE, 4D UTILITY, 2.0L ENG VIN 9REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSHANDLES, LOCKS, LATCHES AND ENTRY SYSTEMSGENERAL PROCEDURESKEYLESS ENTRY KEYPAD CODE PROGRAMMINGREMOTE FUNCTION ACTUATOR (RFA) MODULE KEYLESS ENTRY KEYPAD CODE RESET
2014 Ford Edge SE, 4D Utility, 2.0L Eng VIN 9
Remote Function Actuator (RFA) Module Keyless Entry Keypad Code Reset
2014 Ford Edge SE, 4D Utility, 2.0L Eng VIN 9SECTION Remote Function Actuator (RFA) Module Keyless Entry Keypad Code Reset
NOTE:
This procedure is for transferring the factory keyless entry keycode from the Body Control Module (BCM) and programming it into the Remote Function Actuator (RFA) module.
- Carry out the keyless entry keypad code reset on the scan tool following the on-screen instructions.
- The keyless entry keypad code reset procedure is found on the scan tool under Toolbox>Body>Security.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.