SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014E-150 BASE, VAN CARGO, 4.6L ENG VIN WREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE MECHANICAL - 4.6L (2V)DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIESPISTONASSEMBLY
2014 Ford E-150 Base, Van Cargo, 4.6L Eng VIN W

Disassembly And Assembly Of Subassemblies: Piston: Assembly

2014 Ford E-150 Base, Van Cargo, 4.6L Eng VIN WSECTION Assembly
  1. NOTE: Connecting rod must be installed into piston with identification markings toward front.

    Position the connecting rod in the piston.

    Fig 1: Identifying Piston Identification Mark
    G06138083Courtesy of FORD MOTOR CO.
  2. Lubricate the piston pin and pin bore with clean engine oil.
    Fig 2: Locating Piston Pin
    G06138084Courtesy of FORD MOTOR CO.
  3. Install the piston pin in the piston and connecting rod assembly.
    Fig 3: Locating Piston Pin In Piston And Connecting Rod Assembly
    G06138085Courtesy of FORD MOTOR CO.
  4. Install the piston pin retaining clips in the piston.
    Fig 4: Locating Piston And Connecting Rod Assembly Clips
    G06138080Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.