Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2013EXPLORER POLICE INTERCEPTOR, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS (EXCEPT DIESEL & HYBRID) - DTC P164A - P2A04, DTC U0046- U300CDTC P2096: POST CATALYST FUEL TRIM SYSTEM TOO LEAN BANK 1
2013 Ford Explorer Police Interceptor, FWD
DTC P2096: Post Catalyst Fuel Trim System Too Lean Bank 1
2013 Ford Explorer Police Interceptor, FWDSECTION DTC P2096: Post Catalyst Fuel Trim System Too Lean Bank 1
DTC P2096: POST CATALYST FUEL TRIM SYSTEM TOO LEAN BANK 1
| Description: | The PCM monitors the correction value from downstream heated oxygen sensor (HO2S) as part of the fore-aft oxygen sensor control routine. This DTC sets when the correction value is greater than a calibrated limit. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Inspect the connectors for signs of damage, water ingress, or corrosion. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DZ . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.