DTC P2627: O2 Sensor Pumping Current Trim Circuit Low Bank 1, Sensor 1

2013 Ford Expedition EL King Ranch, RWDSECTION DTC P2627: O2 Sensor Pumping Current Trim Circuit Low Bank 1, Sensor 1
DTC P2627: O2 SENSOR PUMPING CURRENT TRIM CIRCUIT LOW BANK 1, SENSOR 1

Description:  A resistor is installed in the universal heated oxygen sensor (HO2S) connector for part to part variance. The PCM determines the value of this resistor by taking multiple measurements of the resistor during each ignition ON event. The PCM uses this value in order to compensate for the variance in the pumping current signal. This DTC sets when the PCM determines the resistance value is too high.
Possible Causes: 
  • UO2SPCT circuit open
  • UO2SPCT circuit short to ground
  • Contaminated or damaged HO2S
Diagnostic Aids: 
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST DZ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.