Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2013EXPEDITION EL KING RANCH, RWDREPAIR AND DIAGNOSISELECTRICALMOTORS, SWITCHES, RELAYSOEM CONNECTOR END VIEWSTRANSFER CASE CONTROL MODULE (TCCM) CONNECTOR END VIEW (C2371B)
2013 Ford Expedition EL King Ranch, RWD
Transfer Case Control Module (TCCM) Connector End View (C2371B)
2013 Ford Expedition EL King Ranch, RWDSECTION Transfer Case Control Module (TCCM) Connector End View (C2371B)
| Pin | Circuit | Gauge | Circuit Function | Qualifier |
|---|---|---|---|---|
| 1 | CCF03 (GY-BN) | 14 | CTRL MOD. - POWERTRAIN # FOUR WHEEL DRIVE CLUTCH (4WDC) | |
| 2 | * | * | Not Used | |
| 3 | GD133 (BK) | 14 | GROUND - PILLAR A LEFT | |
| 4 | CCF07 (BN-GN) | 14 | CTRL MOD. - POWERTRAIN # FOUR WHEEL DRIVE MOTOR CCW (4WDM) | |
| 5 | CCF08 (GY-OG) | 14 | CTRL MOD. - POWERTRAIN # FOUR WHEEL DRIVE MOTOR CW (4WDM) | |
| 6 | SBB20 (GN-RD) | 14 | FUSE - 20 OR CIRCUIT BREAKER | Expedition |
| 7 | SBB27 (BU-RD) | 14 | FUSE - 27 OR CIRCUIT BREAKER | |
| 8 | * | * | Not Used | |
| 9 | * | * | Not Used | |
| 10 | GD123 (BK-GY) | 14 | GROUND - FENDER FRONT RIGHT | Expedition |
| Available Pigtail Kits | |
|---|---|
| Pigtail Kit Part Number WPT-1042 | Service Part Number: AU2Z-14S411-CA Gauge: 12 14 Pin material: Tin&Silver Cavities: 10 Vehicle Uses
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.