SYS.OK|MANUAL.DB● LIVE
2013 Ford E-150 Base, Van Cargo Extended, 4.6L Eng VIN W

Quick Lookups: Fluids

2013 Ford E-150 Base, Van Cargo Extended, 4.6L Eng VIN WSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil w/o Rear AC 8.00 OZS. 0.23 L PAG 46 S
Air Cond Compressor Oil w/Rear A/C 16.00 OZS. 0.47 L PAG 46 S
Air Cond Refrigerant w/Auxiliary Air Cond 3.38 LBS. 1.53 KG R-134a S
Air Cond Refrigerant w/o Auxiliary Air Cond 1.88 LBS. 0.85 KG R-134a S
Automatic Transmission Fluid 13.90 QTS. 13.15 L MOTORCRAFT Automatic Transmission Fluid MERCON LV Indicates only approximate dry-fill capacity. Some applications may vary based on cooler size and if equipped with an in-tank cooler. The amount of transmission fluid and fluid level should be set by the indication on the dipstick's normal operating range. Use only Automatic Transmission Fluid MERCON LV. S
Brake Fluid N/A N/A MOTORCRAFT High Performance DOT 3 Motor Vehicle Brake Fluid Fill to line on reservoir. S
Differential Gear Oil Dana Conventional Axle Fluid M60 (M248) 6.20 PTS. 2.93 L MOTORCRAFT SAE 80W-90 Premium Rear Axle Lubricant Fill to 1/4" to 9/16" below bottom of fill hole. S
Engine Coolant 4.6L Eng w/Aux Rear Heater 26.00 QTS. 24.6 L MOTORCRAFT Premium Gold Engine Coolant (yellow-colored) Add the coolant type originally equipped in the vehicle. S
Engine Coolant 4.6L Eng w/o Aux Rear Heater 23.80 QTS. 22.52 L MOTORCRAFT Premium Gold Engine Coolant (yellow-colored) Add the coolant type originally equipped in the vehicle. S
Engine Oil 6.00 QTS. 5.67 L MOTORCRAFT SAE 5W-20 Premium Synthetic Blend Motor Oil. MOTORCRAFT SAE 5W-20 Full Synthetic Motor Oil, or equivalent FORD Specification: WSS-M2C945-A. S
Power Steering Fluid N/A N/A MOTORCRAFT Automatic Transmission Fluid MERCON V Keep it in "full" range on dipstick. S
Windshield Washer Fluid N/A N/A MOTORCRAFT Premium Windshield Washer Concentrate Fluid Follow the Manufacturer's Instructions for the mixture ratio. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.