Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Taurus Limited, AWDFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System (Abs) And Stability Control
- Specifications
- Description And Operation
- Diagnosis And Testing
- Anti-Lock Control
- Notes
- Principles of Operation
- Anti-Lock Control
- Electronic Brake Distribution (EBD)
- Traction Control System
- AdvanceTrac® System
- Stability/Traction Control Switch
- Stability/Traction Control Indicators (Sliding-Car Icon)
- Stability Control Sensors
- Hydraulic Power Assist Steering (HPAS) Steering Wheel Angle Sensor
- Steering Angle Sensor Module (SASM)
- ABS Module Configuration
- Inspection and Verification
- DTC Charts
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: DTC B1676
- Pinpoint Test B: DTCs C1145, C1155, C1165 and C1175
- Pinpoint Test C: DTCs C1222, C1296, C1297, C1298 and C1299
- Pinpoint Test D: DTC C1266
- Pinpoint Test E: DTC C1300
- Pinpoint Test F: DTC B2900
- Pinpoint Test G: The Stability Traction Control System is Inoperative or Cannot Be Disabled
- Pinpoint Test H: DTCs C1278, C1956, C1963 and C1975
- Pinpoint Test I: DTCs C1280, C1282, C1963, C1975, U0074, U0151 and U0452
- Pinpoint Test J: DTCs C1288, C1440 and C1446
- Pinpoint Test K: DTC C1105
- Pinpoint Test L: Poor Vehicle Tracking During Anti-lock Function
- Anti-Lock Control
- Removal And Installation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.