Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Low-pressure service gauge port valve cap | 0.8 | - | 7 |
| High-pressure service gauge port valve cap | 0.8 | - | 7 |
| Low-pressure Schrader-type valve | 1.8 | - | 16 |
| High-pressure Schrader-type valve | 2.5 | - | 22 |
| A/C compressor manifold bolt | 20 | 15 | - |
| A/C compressor bolts | 25 | 18 | - |
| Compressor manifold and tube assembly bracket nut | 12 | 9 | - |
| A/C compressor nuts (4.0L) | 25 | 18 | - |
| A/C compressor studs (4.0L) | 13 | 10 | - |
| A/C clutch disc and hub bolt | 13 | 10 | - |
| Speed control actuator bolt | 11 | 8 | - |
| A/C peanut fitting nut | 8 | - | 71 |
| Oil indicator bracket nut | 12 | 9 | - |
| Radiator bolts | 7 | - | 62 |
| Condenser core bolts | 12 | 9 | - |
| Evaporator core housing nuts | 4 | - | 35 |
| Plenum chamber nuts | 4 | - | 35 |
| Suction accumulator inlet fitting | 39 | 29 | - |
| Instrument panel support brace bolts | 9 | - | 80 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.