Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Section 889 (Climate Control)
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Removal And Installation
- Air Conditioning (A/C) Compressor - 2.3L
- Air Conditioning (A/C) Compressor - 3.0L
- Air Conditioning (A/C) Compressor - 4.0L
- Air Conditioning (A/C) Compressor Shaft Seal
- Blower Motor
- Blower Motor Switch
- Climate Control Assembly
- Clutch and Clutch Field Coil
- Compressor Manifold and Tube Assembly - 2.3L
- Compressor Manifold and Tube Assembly - 3.0L
- Compressor Manifold and Tube Assembly - 4.0L
- Compressor to Condenser Discharge Line - 2.3L
- Condenser Core
- Condenser to Evaporator Line
- Evaporator Core
- Evaporator Core Housing
- Evaporator Core Orifice
- Function Selector Switch
- Heater Core
- Plenum Chamber
- Register - Center
- Register - Driver Side
- Register - Passenger Side
- Suction Accumulator
- Temperature Blend Door Actuator
- Vacuum Control Motor - Air Inlet Door
- Vacuum Control Motor - Panel Defrost Door
- Vacuum Control Motor - Panel/Floor Door
- Vacuum Reservoir
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.