WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

TORQUE SPECIFICATIONS

Description	Nm	lb-ft	lb-in
A/C compressor bolt	25	18	-
A/C compressor discharge fitting bolt	9	-	80
A/C compressor nut	25	18	-
A/C compressor stud	9	-	80
A/C compressor suction fitting bolt	9	-	80
Compressor-to-condenser discharge line bracket bolt	7	-	62
Compressor-to-condenser discharge line fitting nut	8	-	71
Condenser bolt	6	-	53
Condenser inlet fitting bolt	6	-	53
Condenser outlet fitting bolt	6	-	53
Condenser-to-evaporator line bracket bolt	9	-	80
Evaporator outlet line bracket stud bolt	11	8	-
Heater core and evaporator core housing nuts	9	-	80
High-pressure Schrader-type valve	3.4	-	30
High-pressure service gauge port valve cap	0.8	-	7
Low-pressure Schrader-type valve	2.26	-	20
Low-pressure service gauge port valve cap	0.8	-	7
Receiver/drier plug	3	-	27
Thermostatic expansion valve (TXV) fitting nut	8	-	71

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Torque Specifications

Use the Manual With the Right Hardware

When to See a Mechanic