Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Focus L4-2.0LFACTORY OEM SERVICE PROCEDURE
Toe Adjustment - Rear
Toe Adjustment - Rear
1. Jounce the vehicle to make sure that the suspension is in its normal resting position.
2. Using alignment equipment and the manufacturer's instructions, measure the toe.
3. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.
4. Loosen the rear lower arm adjustment cam nut.
5. Adjust the toe setting by rotating the nut and eccentric washer.
6. Tighten the rear lower arm adjustment cam nut to 90 Nm (66 lb-ft).
7. Recheck the toe settings, adjust as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
