Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2011EXPEDITION RWDREPAIR AND DIAGNOSISBODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPSUNROOF - ROOF OPENING PANELDIAGNOSIS AND TESTINGROOF OPENING PANELSYMPTOM CHART - ROOF OPENING PANEL

2011 Ford Expedition RWD

Symptom Chart - Roof Opening Panel

2011 Ford Expedition RWDSECTION Symptom Chart - Roof Opening Panel

SYMPTOM CHART - ROOF OPENING PANEL

Condition	Possible Sources	Action
The roof opening panel leaks	Roof opening panel alignment Roof opening panel seal Roof opening panel water trough and rear trough guides Drain tube attachment points Roof opening panel drain hose Front rail sealant Roof opening panel	Go to PINPOINT TEST B .
The roof opening panel does not open or close	Roof opening panel alignment Fuse(s) Circuitry Roof opening panel control switch Roof opening panel motor/module assembly Roof opening panel water trough Roof opening panel rear trough guides Roof opening panel lifter assemblies Roof opening panel motor not initialized	Go to PINPOINT TEST E .
The roof opening panel does not open or close in VENT position	Circuitry Overhead console jumper harness Roof opening panel switch Roof opening panel motor/module assembly	Go to PINPOINT TEST F .
The express open is inoperative	Roof opening panel motor not initialized Roof opening panel motor/module	INITIALIZE the roof opening panel motor/module. Refer to ROOF OPENING PANEL INITIALIZATION in this information. If concern is still present after initialization, INSTALL a new roof opening panel motor/module. Refer to ROOF OPENING PANEL - EXPLODED VIEW and ROOF OPENING PANEL MOTOR in this information. TEST the system for normal operation.
The roof opening panel does not stop in FLUSH from any position	Incorrect roof opening panel alignment	Refer to ROOF OPENING PANEL ALIGNMENT in this information.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.