2011 Ford Escape Hybrid, FWDFACTORY OEM SERVICE PROCEDURE

Front Controls Interface Module (FCIM)

FRONT CONTROLS INTERFACE MODULE (FCIM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
U0140:00 Lost Communication With Body Control Module (GEM  ): No Sub Type Information Go to PINPOINT TEST AA .
U0184:00 Lost Communication With Radio (ACM  ): No Sub Type Information Go to PINPOINT TEST AS .
U2013:63 Switch Pack: Circuit / Component Protection Time-Out Go to PINPOINT TEST R .
U2014:41 Control Module Hardware: General Checksum Failure CLEAR the DTCs. REPEAT the self-test. If DTC U2014:41 is retrieved again, INSTALL a new Front Controls Interface Module (FCIM). Refer to FRONT CONTROLS INTERFACE MODULE (FCIM) in this service information. TEST the system for normal operation.
U201A:51 Control Module Main Calibration Data: Not Programmed CLEAR the DTCs. REPEAT the self-test. If DTC U201A:51 is retrieved again, INSTALL a new FCIM  . Refer to FRONT CONTROLS INTERFACE MODULE (FCIM) in this service information. TEST the system for normal operation.
U3003:16 Battery Voltage: Circuit Voltage Below Threshold Go to PINPOINT TEST AD .
U3003:17 Battery Voltage: Circuit Voltage Above Threshold Go to PINPOINT TEST AN .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.