Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2011ESCAPE 4WD L4-2.5LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIR
2011 Ford Escape 4WD L4-2.5L
Power Window Switch: Service and Repair
2011 Ford Escape 4WD L4-2.5LSECTION Service and Repair
Window Control Switch
Removal and Installation
NOTE: LH front window control switch shown, all others similar.
NOTE: The removal and installation procedures for all window control switches are similar.
1. Remove the front door trim panel or the rear door trim panel. For additional information, refer to Interior Trim and Ornamentation Service and Repair.
2. Release the window control switch bezel from the door trim panel.
3. Release the locking tabs and remove the window control switch from the bezel.
4. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.