Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Escape 4WD L4-2.5LFACTORY OEM SERVICE PROCEDURE
100000 MI or 160000 KM
Inspect
Wheels
Inspect wheels and related components for abnormal noise, wear, looseness or drag.
Vehicle
Recommened Multi-Point Inspection
Universal Joint, Drive/Propeller Shaft
Inspect front axle and U-joints; lubricate if equipped with grease fittings (4WD vehicles).
Steering and Suspension
Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft and U-joints; lubricate if equipped with grease fittings.
Fluid - A/T
Inspect automatic transmission fluid level (if equipped with dip stick).
Exhaust System
Inspect exhaust system and heat shields.
Drive Belt
Inspect accessory drive belt.
Cooling System
Inspect engine cooling system for strength, and hoses.
Constant Velocity Joint Boot
Inspect half-shaft boots (if equipped).
Brakes and Traction Control
Inspect brake pads, shoes, rotors, drums, brake linings, hoses and parking brake.
Replace
Spark Plug
Install new spark plugs.
Oil Filter, Engine
Fluid - Differential
Change rear axle fluid (Dana axles only)
Engine Oil
Coolant
Change engine coolant.
Cabin Air Filter / Purifier
(if equipped)
Rotate
Tires
Rotate tires, inspect for wear and measure tread depth.
Wheels
Inspect wheels and related components for abnormal noise, wear, looseness or drag.
Vehicle
Recommened Multi-Point Inspection
Universal Joint, Drive/Propeller Shaft
Inspect front axle and U-joints; lubricate if equipped with grease fittings (4WD vehicles).
Steering and Suspension
Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft and U-joints; lubricate if equipped with grease fittings.
Fluid - A/T
Inspect automatic transmission fluid level (if equipped with dip stick).
Exhaust System
Inspect exhaust system and heat shields.
Drive Belt
Inspect accessory drive belt.
Cooling System
Inspect engine cooling system for strength, and hoses.
Constant Velocity Joint Boot
Inspect half-shaft boots (if equipped).
Brakes and Traction Control
Inspect brake pads, shoes, rotors, drums, brake linings, hoses and parking brake.
Replace
Spark Plug
Install new spark plugs.
Oil Filter, Engine
Fluid - Differential
Change rear axle fluid (Dana axles only)
Engine Oil
Coolant
Change engine coolant.
Cabin Air Filter / Purifier
(if equipped)
Rotate
Tires
Rotate tires, inspect for wear and measure tread depth.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.