Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2010TRANSIT CONNECT VAN CARGOREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSTRANSMISSION COOLER - TRANSAXLE/TRANSMISSION COOLINGREMOVAL AND INSTALLATIONTRANSMISSION FLUID COOLERINSTALLATION

2010 Ford Transit Connect Van Cargo

Transmission Fluid Cooler: Installation

2010 Ford Transit Connect Van CargoSECTION Installation

Position the transmission fluid cooler in place.

Fig 1: Locating Transmission Fluid Cooler
Courtesy of FORD MOTOR CO.
Install the transmission fluid cooler onto the transmission fluid cooler bracket.

Fig 2: Installing Transmission Fluid Cooler Onto Transmission Fluid Cooler Bracket
Courtesy of FORD MOTOR CO.

NOTE: If the transmission fluid cooler tube latches are not in the unlocked position, compress the tabs on the transmission fluid cooler tube latches and slide the latch out of the transmission fluid cooler tube to unlock the latch.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.