Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010TRANSIT CONNECT VAN CARGOREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1239 (ENGINE CONTROLS - ELECTRONIC ENGINE CONTROLS - 3.5L)REMOVAL AND INSTALLATIONPOWERTRAIN CONTROL MODULE (PCM)REMOVAL
2010 Ford Transit Connect Van Cargo
Powertrain Control Module (PCM): Removal
2010 Ford Transit Connect Van CargoSECTION Removal
WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI)
.NOTE: PCM replacement DOES NOT require new keys or programming of keys.
- Remove the battery tray. For additional information, refer to REMOVAL AND INSTALLATION .
- Disconnect the 2 PCM electrical connectors.
- Remove the 4 bolts and the PCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.