Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010TRANSIT CONNECT VAN CARGOREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE SYSTEM - GENERAL INFORMATIONGENERAL PROCEDURESVALVE STEM TO VALVE GUIDE CLEARANCESPECIAL TOOL(S)
2010 Ford Transit Connect Van Cargo
Special Tool(s)
2010 Ford Transit Connect Van CargoSECTION Special Tool(s)
SPECIAL TOOL REFERENCE
| Clearance Gauge, Valve Guide 303-004 (TOOL-6505-E) or equivalent |
|
| Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent |
NOTE:
Refer to the appropriate information in
ENGINE - 2.0L
for the specification.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.