Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010TRANSIT CONNECT VAN CARGOREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE SYSTEM - GENERAL INFORMATIONGENERAL PROCEDURESPISTON RING-TO-GROOVE CLEARANCESPECIAL TOOL(S)
2010 Ford Transit Connect Van Cargo
Special Tool(s)
2010 Ford Transit Connect Van CargoSECTION Special Tool(s)
SPECIAL TOOL REFERENCE
| Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent |
NOTE:
Refer to
ENGINE - 2.0L
for the specification.
- Inspect the piston for ring land damage or accelerated wear.
- Using the Feeler Gauge Set, measure the piston ring-to-groove clearance.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.