Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010TRANSIT CONNECT VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION - AUTOMATIC TRANSAXLE/TRANSMISSIONSPECIFICATIONSTORQUE SPECIFICATIONS
2010 Ford Transit Connect Van Cargo
Torque Specifications
2010 Ford Transit Connect Van CargoSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Description | N.m | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| Converter housing-to-transaxle case bolts and stud | 22 | 16 | - | ||
| Electrical connector bracket nuts | 25 | 18 | - | ||
| Final drive input gear bearing retainer nut pre-torque | 400 | 295 | - | ||
| Final drive input gear bearing retainer nut rotational torque | 0.4-0.7 | - | 3.5-6.2 | ||
| Intermediate/Overdrive (O/D) band anchor bolt | 45 | 33 | - | ||
| Intermediate/O/D band servo cover bolts(1) | - | - | - | ||
| Intermediate shaft bearing cap locknuts | 25 | 18 | - | ||
| Line pressure tap plug | 13 | - | 115 | ||
| Main control valve body bolts(1) | - | - | - | ||
| Main control ground wire bolt | 10 | - | 89 | ||
| Manual control lever bolt | 30 | 22 | - | ||
| Output Shaft Speed (OSS) sensor bolt | 10 | - | 89 | ||
| Parking pawl assembly bolts | 13 | - | 115 | ||
| Pump bolts | 10 | - | 89 | ||
| Pump-to-case bolts(1) | - | - | - | ||
| Roll restrictor bolts | 70 | 52 | - | ||
| Selector lever cable bracket bolts | 25 | 18 | - | ||
| Shim selection bolts | 5 | - | 44 | ||
| Solenoid body bolts(1) | - | - | - | ||
| Torque converter-to-flexplate nuts | 40 | 30 | - | ||
| Transaxle end cover bolts | 22 | 16 | - | ||
| Transaxle filler tube bolts | 8 | - | 71 | ||
| Transaxle support insulator bracket nuts | 80 | 59 | - | ||
| Transaxle support insulator-to-body nuts | 48 | 35 | - | ||
| Transaxle support insulator-to-bracket nut | 150 | 111 | - | ||
| Transaxle-to-engine bolts | 47 | 35 | - | ||
| Transmission band select gauge(1) | - | - | - | ||
| Transmission fluid pan bolts | 10 | - | 89 | ||
| Transmission Range (TR) sensor bolts | 10 | - | 89 | ||
| Turbine Shaft Speed (TSS) sensor bolt | 10 | - | 89 | ||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.