Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010TRANSIT CONNECT VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORSWITCHES
2010 Ford Transit Connect Van Cargo
Electrical Component Locator: Switches
2010 Ford Transit Connect Van CargoSECTION Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| A/C Compressor Cycling Switch | Right rear of engine compartment. See Figure. |
| Brake Fluid Level Switch | On master cylinder reservoir. See Figure. |
| Brake Pedal Position Switch | Brake pedal support bracket. See Figure. |
| Door Ajar Switch (Left Front) | Left kick panel. See Figure. |
| Door Ajar Switch (Rear Doors) | Right "D" pillar. See Figure. |
| Door Ajar Switch (Right Front) | Right kick panel. See Figure. |
| Horn Switch | Steering wheel. See Figure. |
| Inertia Fuel Shutoff (IFS) Switch | Right kick panel. See Figure. |
| Oil Pressure Switch | Lower left side of engine. See Figure. |
| Park Brake Switch | Center console. See Figure. |
| Sliding Door Ajar Switch (Left) | Base of left "C" pillar. See Figure. |
| Sliding Door Ajar Switch (Right) | Base of right "C" pillar. See Figure. |
| Sliding Door Contact Switch (Left) | Base of left "B" pillar. See Figure. |
| Sliding Door Contact Switch (Right) | Base of right "B" pillar. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.