Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010TRANSIT CONNECT VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)MAINTENANCEPROCEDURESMAINTENANCE SCHEDULEDESCRIPTION AND OPERATIONMAINTENANCE SCHEDULES - GASOLINE ENGINESNORMAL SCHEDULE36,000 KM (22,500 MI)
2010 Ford Transit Connect Van Cargo
36,000 km (22,500 mi)
2010 Ford Transit Connect Van CargoSECTION 36,000 km (22,500 mi)
- Change engine oil and install a new oil filter.
- Perform multi-point inspection (recommended).
- Inspect cabin air filter (if equipped).
- Rotate tires, inspect tires for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only be rotated if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.