Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010TRANSIT CONNECT VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - PINPOINT TEST JD: CRANKSHAFT POSITION (CKP) SENSOR THROUGH PINPOINT TEST KJ: SUPERCHARGER BYPASS CONTROL - (EXCEPT DIESEL & HYBRID)PINPOINT TEST JE: INTEGRATED IGNITION COIL PACK A, B, OR C FAILURENOTES
2010 Ford Transit Connect Van Cargo
Pinpoint Test JE: Integrated Ignition Coil Pack A, B, or C Failure: Notes
2010 Ford Transit Connect Van CargoSECTION Notes
NOTE:
Proceed to DTC testing steps listed in FAULT CODE SETTING CONDITION table of fault code setting condition.
FAULT CODE SETTING CONDITION
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Coil-on-plug (COP) ignition testing | - | GO to PINPOINT TEST JF . | GO to PINPOINT TEST JF . |
| Coil pack ignition testing | - | GO to PINPOINT TEST JE . | GO to PINPOINT TEST JE . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.