Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection and Verification
2010 Ford Taurus SEL, FWDSECTION Inspection and Verification
WARNING: This page is about a different variant/trim than selected.
- Verify the customer concern.
- Inspect for obvious signs of mechanical damage.VISUAL INSPECTION CHART
Mechanical - Power Transfer Unit (PTU)
- Halfshafts and CV joints
- Driveshaft and U-joints
- Wheel/tire size and brand
- Matching tire size and brand
- Tire pressure
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, verify the symptom and GO to SYMPTOM CHART .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.