Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010RANGER 2WD L4-2.3LREPAIR AND DIAGNOSISSPECIFICATIONSCAPACITY SPECIFICATIONSDIFFERENTIAL ASSEMBLYSYSTEM SPECIFICATIONS
2010 Ford Ranger 2WD L4-2.3L
System Specifications
2010 Ford Ranger 2WD L4-2.3LSECTION System Specifications
Rear Axle 5.0-5.3 pints (2.4-2.5 L)
Note: Traction-Lok axles use 4.75-5.0 pints (2.2-2.4 L) of rear axle lubricant.
Note: Service refill capacities are determined by filling the rear axle 1/4 inch to 9/16 inch (6 mm to 14 mm) below the bottom of the filler hole.
Note: Add 4 oz. (118 ml) of Additive Friction Modifier XL-3 or equivalent meeting Ford specification EST-M2C118-A for complete refill of Traction-Lok axles.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.