Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (CLUTCH SYSTEM)REMOVAL AND INSTALLATIONPILOT BEARINGINSTALLATION
2010 Ford Mustang Base, 2D Coupe, Automatic
Pilot Bearing: Installation
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Installation
WARNING: This page is about a different variant/trim than selected.
- Position the pilot bearing to the crankshaft. Using a suitable driver, install the pilot bearing.
- Install the clutch disc and the clutch pressure plate. For additional information, refer to CLUTCH DISC AND PRESSURE PLATE - 4.0L , CLUTCH DISC AND PRESSURE PLATE - 4.6L or CLUTCH DISC AND PRESSURE PLATE - 5.4L .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.