Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (ENGINE MECHANICAL - 5.4L (4V))SPECIFICATIONSTORQUE SPECIFICATIONS
2010 Ford Mustang Base, 2D Coupe, Automatic
Torque Specifications
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Torque Specifications
WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| A/C compressor stud bolts | 25 | 18 | - | ||
| A/C compressor wiring harness retainer bolt | 20 | - | 177 | ||
| A/C tube support bracket nut | 9 | - | 80 | ||
| Accessory drive belt idler pulley (smooth and grooved) bolt | 25 | 18 | - | ||
| Accessory drive belt tensioner bolt | 25 | 18 | - | ||
| Alternator bolts | 50 | 37 | - | ||
| Camshaft bearing cap bolts(1) | - | - | - | ||
| Camshaft drive sprocket bolts(1) | - | - | - | ||
| Camshaft Position (CMP) sensor bolt | 10 | - | 89 | ||
| Charge Air Cooler (CAC) bolts(1) | - | - | - | ||
| CAC coolant tube assembly bolts | 10 | - | 89 | ||
| Connecting rod cap bolts(1) | - | - | - | ||
| Coolant pump bolts | 25 | 18 | - | ||
| Coolant pump pulley bolts | 25 | 18 | - | ||
| Coolant tube assembly bolts | 10 | - | 89 | ||
| Coolant tube bracket nut | 9 | - | 80 | ||
| Cooling fan assembly bolts | 9 | - | 80 | ||
| Crankshaft Position (CKP) sensor bolt | 10 | - | 89 | ||
| Crankshaft pulley bolt(1) | - | - | - | ||
| Crankshaft rear seal retainer plate bolts(1) | - | - | - | ||
| Cylinder head bolts(1) | - | - | - | ||
| EGR system module bolts | 25 | 18 | - | ||
| EGR tube | 40 | 30 | - | ||
| Engine block drain plugs | 14 | - | 124 | ||
| Engine front cover bolts(1) | - | - | - | ||
| Engine support insulator bolts | 55 | 41 | - | ||
| Engine support insulator bracket bolts | 80 | 59 | - | ||
| Engine support insulator nuts | 63 | 46 | - | ||
| Exhaust manifold nuts(1) | - | - | - | ||
| Exhaust manifold studs | 12 | - | 106 | ||
| Flywheel(1) | - | - | - | ||
| Fuel rail bolts | 10 | - | 89 | ||
| Generator B+ wire terminal nut | 8 | - | 71 | ||
| Generator bolts and stud bolt | 50 | 37 | - | ||
| Ground wire-to-LH cylinder head bolt | 10 | - | 89 | ||
| Ground wire-to-RH engine support insulator nut | 25 | 18 | - | ||
| Hood bolts | 12 | - | 106 | ||
| Ignition coil-on-plug cover bolts | 10 | - | 89 | ||
| Intake Air Temperature 2 (IAT2) sensor | 15 | - | 133 | ||
| Intake manifold assembly bolts(1) | - | - | - | ||
| Intake manifold wiring harness bracket bolts | 10 | - | 89 | ||
| Intermediate steering shaft bolt | 47 | 35 | - | ||
| Knock Sensor (KS) bolts | 20 | - | 177 | ||
| Lower intake manifold cover bolts(1) | - | - | - | ||
| Main bearing cap bolts(1) | - | - | - | ||
| Main bearing cap side bolts(1) | - | - | - | ||
| Oil cooler bolts(1) | - | - | - | ||
| Oil filter(1) | - | - | - | ||
| Oil filter adapter bolts(1) | - | - | - | ||
| Oil level indicator tube bolt | 10 | - | 89 | ||
| Oil pan bolts(1) | - | - | - | ||
| Oil pan drain plug | 26 | 19 | - | ||
| Oil pan stud bolt wire harness bracket retainer nut | 10 | - | 89 | ||
| Oil pan-to-engine front cover bolts | 25 | 18 | - | ||
| Oil pan-to-engine front cover stud bolt | 25 | 18 | - | ||
| Oil pump bolts(1) | - | - | - | ||
| Oil pump screen and pickup tube bolts (large) | 25 | 18 | - | ||
| Oil pump screen and pickup tube bolts (small) | 10 | - | 89 | ||
| Power Distribution Box (PDB) connector bolt | 6 | - | 53 | ||
| Power Steering Pressure (PSP) tube fitting | 65 | 48 | - | ||
| Power steering pump bolts | 25 | 18 | - | ||
| Power steering reservoir bracket bolts | 25 | 18 | - | ||
| Power steering tube bracket bolt | 10 | - | 89 | ||
| Power steering tube bracket nut | 10 | - | 89 | ||
| Radio interference capacitor nuts | 10 | - | 89 | ||
| Spark plugs | 18 | - | 159 | ||
| Starter B+ terminal nut | 12 | - | 106 | ||
| Starter bolts(1) | - | - | - | ||
| Starter S-terminal nut | 5 | - | 44 | ||
| Steering column dash boot nuts | 9 | - | 80 | ||
| Subframe bolts | 115 | 85 | - | ||
| Subframe cross brace nuts | 48 | 35 | - | ||
| Subframe nuts | 115 | 85 | - | ||
| Supercharger (SC) bolts(1) | - | - | - | ||
| SC drive belt heavy load idler (closest to centerline of engine) bolt | 48 | 35 | - | ||
| SC drive belt idler (smooth and grooved) bolts | 25 | 18 | - | ||
| SC drive belt tensioner bolt | 48 | 35 | - | ||
| Thermostat housing nuts | 25 | 18 | - | ||
| Throttle Body (TB) and spacer bolts | 10 | - | 89 | ||
| Timing chain guide bolts | 10 | - | 89 | ||
| Timing chain tensioner bolts (primary) | 25 | 18 | - | ||
| Timing chain tensioner bolts (secondary) | 10 | - | 89 | ||
| Valve cover bolts(1) | - | - | - | ||
| Windage tray nuts(1) | - | - | - | ||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.