Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE MECHANICAL - 4.6L (3V))IN-VEHICLE REPAIRINTAKE MANIFOLDMATERIAL
2010 Ford Mustang Base, 2D Coupe, Automatic
Intake Manifold: Material
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Material
WARNING: This page is about a different variant/trim than selected.
MATERIAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Motorcraft® Metal Surface Prep ZC-31-A |
- |
ITEM DESCRIPTION
| Item | Part Number | Description |
|---|---|---|
| 1 | 14A464 | Charge Motion Control Valve (CMCV) electrical connector (part of 12B637) |
| 2 | 9F792 | Vacuum hose T-fitting |
| 3 | - | Wiring harness retainer (part of 12B637) |
| 4 | - | Wiring harness pin-type retainer (part of 12B637) |
| 5 | 9G271 | Evaporative Emission (EVAP) tube |
| 6 | 6K817 | PCV tube |
| 7 | 14A464 | Electronic Throttle Body (TB) electrical connector (part of 12B637) |
| 8 | 14A464 | Throttle Position (TP) sensor electrical connector (part of 12B637) |
| 9 | W710758 | Intake manifold bolt (9 required) |
| 10 | W713564 | Intake manifold stud bolt |
| 11 | 9424 | Intake manifold |
| 12 | 9439 | Intake manifold gasket (2 required) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.