Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 935 (MULTIFUNCTION ELECTRONIC MODULES SYSTEM)REMOVAL AND INSTALLATIONSMART JUNCTION BOX (SJB)INSTALLATION
2010 Ford Mustang Base, 2D Coupe, Automatic
Smart Junction Box (SJB): Installation
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Install the SJB.
- Connect the electrical connectors.
- Install the screw.
- Install the floor console finish panel.
- Install the parking brake lever boot into the floor console finish panel.
- Release the parking brake.
- Install the transmission selector lever bezel into the floor console finish panel.
- Install the floor console SJB cover.
- Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
- Download the SJB configuration information from the scan tool. For additional information, refer to MODULE CONFIGURATION article.
- Carry out TPMS sensor training. For additional information, refer to WHEELS AND TIRES article.
NOTE:
When successful, this step clears the manufacturing mode DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.