SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 378 (ANTI-LOCK BRAKE SYSTEM - VEHICLE DYNAMIC SYSTEMS)DIAGNOSIS AND TESTINGANTI-LOCK CONTROLPINPOINT TESTSPINPOINT TEST A: NO COMMUNICATION WITH THE ANTI-LOCK BRAKE SYSTEM (ABS) MODULEOVERVIEW
2010 Ford Mustang Base, 2D Coupe, Automatic

Pinpoint Test A: No Communication With The Anti-Lock Brake System (Abs) Module: Overview

2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Overview
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Use the flex probe kit for all test connections to prevent damage to the wiring terminals. Do not use standard multimeter probes.
  1. A1 CHECK CIRCUIT 677 (LB) AND CIRCUIT 483 (RD) FOR AN OPEN 
    • Key in OFF position.
    • For vehicles equipped with a 3.0L engine  , with the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .
    • Disconnect: ABS Module C155.
    • Key in ON position.
    • Measure the voltage between ABS module C155-4, circuit 677 (LB), harness side and ground; and between ABS module C155-32, circuit 483 (RD), harness side and ground.
      Fig 1: Checking Circuit 677 (LB) & Circuit 483 (RD) For An Open
      G04617713Courtesy of FORD MOTOR CO.
    • Are the voltages greater than 10 volts? 

    Yes:  GO to  A2.

    No:  REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test.

  2. A2 CHECK CIRCUIT 570 (BK/WH) FOR AN OPEN 
    • Key in OFF position.
    • Measure the resistance between ABS module C155-16, circuit 570 (BK/WH) harness side and ground.
      Fig 2: Checking Circuit 570 (BK/WH) For An Open
      G04617714Courtesy of FORD MOTOR CO.
    • Is the resistance less than 5 ohms? 

    Yes:  CHECK the module communications network. REFER to MODULE COMMUNICATIONS NETWORK .

    No:  REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.