Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1544 (ELECTRONIC ENGINE CONTROLS (HYBRID))REMOVAL AND INSTALLATIONPOWERTRAIN CONTROL MODULE (PCM)REMOVAL
2010 Ford Mustang Base, 2D Coupe, Automatic
Powertrain Control Module (PCM): Removal
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Removal
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to JACKING & LIFTING article.
- Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION -- FUSION MILAN & MKZ article.
- Remove the cowl panel grille. For additional information, refer to FRONT END BODY PANELS -- FUSION, MILAN & MKZ .
- Disconnect the vacuum hose from the vacuum brake booster.
- Disconnect the 3 PCM electrical connectors.
- Remove the ground strap bolt and disconnect the ground strap retainer.
- Remove the two LH splash shield pin-type retainers and position the LH splash shield aside.
- Remove the lower PCM bolt and the upper PCM bracket bolt.
- Remove the PCM.
- Remove the upper PCM bolt and the PCM bracket from the PCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.