Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1442 (HVAC - CLIMATE CONTROL SYSTEM)SPECIFICATIONSTORQUE SPECIFICATIONS
2010 Ford Mustang Base, 2D Coupe, Automatic
Torque Specifications
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Torque Specifications
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| A/C clutch disc and hub bolt | 13 | 10 | - |
| A/C compressor stud | 25 | 18 | - |
| A/C peanut fitting nut | 15 | 11 | - |
| A/C pressure relief valve | 10 | - | 89 |
| Compressor fitting nut | 15 | 11 | - |
| Condenser fitting nut | 15 | 11 | - |
| Cooling module bracket bolts | 10 | - | 89 |
| Front safety belt anchor bolt | 40 | 30 | - |
| Heater tube bracket nut and stud | 12 | 9 | - |
| High-pressure Schrader-type valve | 2.5 | - | 22 |
| High-pressure service gauge port valve cap | 0.8 | - | 7 |
| Low-pressure Schrader-type valve | 1.8 | - | 16 |
| Low-pressure service gauge port valve cap | 0.8 | - | 7 |
| Suction accumulator bolts | 15 | 11 | - |
| Vapor management valve (VMV) nuts | 6 | - | 53 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.