Heater Hose: Notes

2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Notes
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heater Hose Replacement Components (With Torque Specifications ) (1 Of 2)
GF0018931Courtesy of FORD MOTOR CO.
Item Part Number Description
1 - RH cowl grille screw (2 required)
2 018A16 RH cowl grille
3 W704759 RH cowl extension screw (5 required)
4 N620480 Upper vapor management valve (VMV) bracket nut (2 required)
5 19C928 RH cowl extension
Fig 2: Identifying Heater Hose Components (2 Of 2)
GF0018932Courtesy of FORD MOTOR CO.
Item Part Number Description
6 - VMV fitting (2 required) (part of 9C915)
7 12B637 VMV electrical connector
8 N621927 Lower VMV bracket nut
9 9C915 VMV and bracket
10 8287 Heater inlet hose clamp (2 required)
11 18472 Heater inlet hose
12 8287 Heater outlet hose clamp (2 required)
13 18472 Heater outlet hose
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.