SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 144 (ENGINE)IN-VEHICLE REPAIRCYLINDER HEAD - RHINSTALLATION
2010 Ford Mustang Base, 2D Coupe, Automatic

Cylinder Head - RH: Installation

2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths.
  1. Use a plastic scraping tool to remove all traces of the head gasket.
    • Clean all surfaces with silicone gasket remover and metal surface prep.
  2. Position the new gasket and the cylinder head.
    3. NOTE: New cylinder head bolts must be installed. They are torque-to-yield designed and cannot be reused.
  3. Install the 8 bolts and tighten in 6 stages in the sequence shown.
    • Stage 1: Tighten to 40 Nm (30 lb-ft).
    • Stage 2: Tighten 90 degrees.
    • Stage 3: Loosen 1 full turn.
    • Stage 4: Tighten to 40 Nm (30 lb-ft).
    • Stage 5: Tighten 90 degrees.
    • Stage 6: Tighten 90 degrees.
      Fig 1: Installing Bolts
      G03898353Courtesy of FORD MOTOR CO.
    4. CAUTION: The hydraulic lash adjusters must be installed in their original positions.
  4. Install the hydraulic lash adjusters.
    • Lubricate the hydraulic lash adjusters with clean engine oil.
    5. CAUTION: The camshaft roller followers must be installed in their original positions.
  5. Install the camshaft roller followers.
    • Lubricate the camshaft roller followers with clean engine oil.
  6. Position a new gasket, the RH exhaust manifold and install the 6 nuts.
    • Tighten to 20 Nm (15 lb-ft).
      Fig 2: Positioning Gasket
      G03990179Courtesy of FORD MOTOR CO.
  7. Position the PSP tube bracket and install the bolt.
    • Tighten to 7 Nm (62 lb-in).
  8. Install the RH camshafts. For additional information, refer to VALVE COVER - RH .
  9. Install the coolant bypass tube. For additional information, refer to ENGINE COOLING .
  10. Install the lower intake manifold. For additional information, refer to LOWER INTAKE MANIFOLD .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.