Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - PINPOINT TEST DY: ENGINE OIL TEMPERATURE (EOT) SENSOR THROUGH PINPOINT TEST HE: EXHAUST GAS RECIRCULATION (EGR) SYSTEMS - (EXCEPT DIESEL & HYBRID)PINPOINT TEST FB: POWER TAKE OFF (PTO)INTRODUCTION
2010 Ford Mustang Base, 2D Coupe, Automatic
Pinpoint Test FB: Power Take Off (PTO): Introduction
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Introduction
This pinpoint test is intended to diagnose the following:
- PTO switch
- harness circuit: PTO and PTOIL
- powertrain control module (PCM) (12A650)
For PCM connector views or reference values, refer to REFERENCE VALUES .
POWERTRAIN CONTROL MODULE (PCM) CONNECTOR PIN REFERENCE CHART
| Vehicle | Connector | Pin | Circuit |
|---|---|---|---|
| E-Series 6.8L, F-Series Super Duty |
170 Pin | B7 B42 B9 B26 |
PTORPM PTOIL PTOENG PTO |
| All other vehicles | 190-Pin | B8 B11 B6 B3 |
PTORPM PTOIL PTOENG PTO |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.