Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMESEAT SYSTEM - SEATSREMOVAL AND INSTALLATIONSEAT CONTROL SWITCHINSTALLATION
2010 Ford Mustang Base, 2D Coupe, Automatic
Seat Control Switch: Installation
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Installation
- Install a new cushion side shield.
- Install the seat control switch.
- Install the switch into the side shield.
- Install the knob.
- Connect the electrical connector.
- If equipped, install the power lumbar switch.
- Install the switch into the side shield.
- Connect the electrical connector.
- Make sure all the side shield retainers are attached to the side shield.
- Install the side shield and screw to the seat.
- Install the seat control switch.
- Install the recline handle and clip.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.