Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISDTC P1235: FUEL PUMP CONTROL OUT OF RANGE
2010 Ford Mustang Base, 2D Coupe, Automatic
DTC P1235: Fuel Pump Control Out Of Range
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION DTC P1235: Fuel Pump Control Out Of Range
DTC P1235: FUEL PUMP CONTROL OUT OF RANGE
| Description: | This DTC indicates the fuel pump driver module (FPDM) detected an invalid or missing fuel pump (FP) duty cycle signal on the fuel pump control (FPC) circuit from the powertrain control module (PCM). The FPDM sends a message to the PCM through the fuel pump monitor (FPM) circuit, indicating this concern was detected. The PCM sets the DTC when the message is received. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The FPDM sends a 25% duty cycle (250 ms on, 750 ms off) through the FPM circuit to the PCM while the concern is being detected by the FPDM. If the concern is no longer detected, the FPDM returns to sending an all OK (50% duty cycle) message to the PCM. For ETC applications, check if ETC DTC P2105 is present. An ETC system concern could cause DTC P1235, and should be diagnosed first. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST KB . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.