Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SYMPTOM CHARTS (EXCEPT DIESEL & HYBRID)NO DIAGNOSTIC TROUBLE CODES (DTCS) PRESENT SYMPTOM CHARTSCHART 18
2010 Ford Mustang Base, 2D Coupe, Automatic
Chart 18
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Chart 18
- Exhaust System Concerns: Visible Smoke
NOTE:
Black smoke indicates a rich fuel mixture, blue smoke indicates burning oil, and white smoke indicates water in the combustion chamber.
EXHAUST SYSTEM CONCERNS: VISIBLE SMOKE SYMPTOM CHART
| SYSTEM/COMPONENT | REFERENCE (article 5 Pinpoint Test unless noted) |
|---|---|
| Base Engine | REFER to the appropriate Engine System article and carry out the Inspection and Verification to continue diagnosis. |
Fuel Delivery System
|
GO to PINPOINT TEST HC . |
Ignition System
|
For vehicles equipped with a coil pack ignition system, GO to PINPOINT TEST JC
. For all others, GO to PINPOINT TEST JB . |
Positive Crankcase Ventilation (PCV) System
|
REFER to the appropriate Engine System article for a description of the Oil Consumption Test. |
Turbocharger System
|
REFER to the appropriate Fuel Charging and Controls - Turbocharger article for the Oil Consumption Test. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.