Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010MUSTANG BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEAT SYSTEM - SEATSREMOVAL AND INSTALLATIONSEAT BACKREST HEATER MATINSTALLATION
2010 Ford Mustang Base, 2D Coupe, Automatic
Seat Backrest Heater Mat: Installation
2010 Ford Mustang Base, 2D Coupe, AutomaticSECTION Installation
- Install a new backrest foam pad to the backrest frame.
- Install the new heater mat to the new foam pad.
- Remove the paper strips from the new heater mat.
- Align the heater mat square to the backrest foam pad with the wiring toward the lower edge.
- Apply the heater mat flat on the foam pad surface without any wrinkles and correctly tuck into the valley of the foam pad.
- Route the backrest heater mat wire harness as noted in removal and connect the electrical connector.
- Install the backrest cover. For additional information, refer to SEAT BACKREST COVER - FRONT .
NOTE:
Install the new heater mat straight on the foam pad and without any wrinkles that may show through the backrest cover after installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.