SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FUSION SEL, 2.5 AREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISDTC P1901: TURBINE SHAFT SPEED (TSS) SENSOR CIRCUIT INTERMITTENT
2010 Ford Fusion SEL, 2.5 A

DTC P1901: Turbine Shaft Speed (TSS) Sensor Circuit Intermittent

2010 Ford Fusion SEL, 2.5 ASECTION DTC P1901: Turbine Shaft Speed (TSS) Sensor Circuit Intermittent
DTC P1901: TURBINE SHAFT SPEED (TSS) SENSOR CIRCUIT INTERMITTENT

Description:  The TSS sensor signal to the powertrain control module (PCM) is irregular or interrupted.
Possible Causes: 
  • Harness connector not correctly seated
  • Harness intermittently short or open
  • Harness connector damaged
  • TSS sensor damaged or not installed correctly
Diagnostic Aids:  Verify harness and connector integrity.
Verify correct installation of the TSS sensor.
Refer to the Pinpoint Test Turbine Shaft Speed Sensor in the appropriate AUTOMATIC TRANSMISSION/TRANSAXLE article to continue diagnosis.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the appropriate DTC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.