Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS SES, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - PINPOINT TEST HF: CATALYST EFFICIENCY MONITOR AND EXHAUST SYSTEMS THROUGH PINPOINT TEST JC: SECONDARY IGNITION (COIL PACK) - (EXCEPT DIESEL & HYBRID)PINPOINT TEST HG: POSITIVE CRANKCASE VENTILATION (PCV) SYSTEMINTRODUCTION
2010 Ford Focus SES, 4D Sedan, Standard
Pinpoint Test HG: Positive Crankcase Ventilation (PCV) System: Introduction
2010 Ford Focus SES, 4D Sedan, StandardSECTION Introduction
This pinpoint test is intended to diagnose the following:
- positive crankcase ventilation (PCV) valve (6A666) and related vacuum lines
- electrically heated PCV valve (6A666) and heater circuit
- electrically heated PCV fitting (9F624) and heater circuit
- powertrain control module (PCM) (12A650)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.