Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS SES, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXSTARTING SYSTEM DTCS
2010 Ford Focus SES, 4D Sedan, Standard
Starting System DTCS
2010 Ford Focus SES, 4D Sedan, StandardSECTION Starting System DTCS
PCM DTC Chart
| DTC | Description | Action |
|---|---|---|
| P0512 | Starter Request Circuit - Circuit has Power With the Ignition in the OFF Position | CARRY OUT the Ignition Switch Component Test. Refer to Component Tests for component testing. If necessary, INSTALL a new ignition switch. If the ignition switch passed the component test, REPAIR circuit CDC35 (BU/WH) for a short to power. |
| P0705 | Transmission Range (TR) Sensor Circuit Failure | Refer to the AUTOMATIC TRANSAXLE/TRANSMISSION - 4F27E for the procedure. |
| P1702 | TR Sensor Circuit Failure | Refer to the AUTOMATIC TRANSAXLE/TRANSMISSION - 4F27E for the procedure. |
| P1705 | TR Sensor Circuit Failure | Refer to the AUTOMATIC TRANSAXLE/TRANSMISSION - 4F27E for the procedure. |
| P0830 | Clutch Pedal Switch A Circuit | REFER to INTRODUCTION - GASOLINE MODELS . |
| P0833 | Clutch Pedal Switch B Circuit | REFER to INTRODUCTION - GASOLINE MODELS . |
| P1260 | Theft Detected, Vehicle Immobilized | REFER to the DTC Chart in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.