DTC P2282: Air Leak Between Throttle Body And Intake Valve

2010 Ford Focus SES, 4D Sedan, StandardSECTION DTC P2282: Air Leak Between Throttle Body And Intake Valve
DTC P2282: AIR LEAK BETWEEN THROTTLE BODY AND INTAKE VALVE

Description:  This DTC sets when the powertrain control module (PCM) detects an air leak that exceeds a predetermined limit for greater than 5 seconds. If the air flow entering the engine exceeds the air flow through the throttle, a leak is detected and this diagnostic fails.
Possible Causes: 
  • Unmetered air leaks between throttle body and intake valves
  • Air leaks at the intake manifold
  • Positive crankcase ventilation (PCV) system is leaking or the valve is stuck open
Diagnostic Aids:  Verify the integrity of the PCV system. Refer to POSITIVE CRANKCASE VENTILATION (PCV) SYSTEM for system information.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST HG .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.