Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS SES, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALENGINE MECHANICAL - 2.0LIN-VEHICLE REPAIRENGINE MOUNTREMOVAL AND INSTALLATION
2010 Ford Focus SES, 4D Sedan, Standard
Removal and Installation
2010 Ford Focus SES, 4D Sedan, StandardSECTION Removal and Installation
- Remove the 2 expansion tank bolts.
- To install, tighten to 4 Nm (35 lb-in).
- Lift the coolant expansion tank off of the engine mount stud bolt and position it aside.
- Install the Engine Support Bar.
- Remove the 2 engine mount nuts.
- To install, tighten to 90 Nm (66 lb-ft).
- Remove the 2 bolts, stud bolt and the engine mount.
- To install, tighten to 48 Nm (35 lb-ft).
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.