Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS SES, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALEXHAUST SYSTEMSPECIFICATIONSTORQUE SPECIFICATION
2010 Ford Focus SES, 4D Sedan, Standard
Torque Specification
2010 Ford Focus SES, 4D Sedan, StandardSECTION Torque Specification
TORQUE SPECIFICATION
| Description | Nm | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| Catalytic converter bracket bolt | 18 | - | 159 | ||
| Catalytic converter bracket-to-engine bracket bolts | 23 | 17 | - | ||
| Catalytic converter-to-cylinder head nuts(1) | - | - | - | ||
| Catalytic converter-to-cylinder head studs | 17 | - | 150 | ||
| Catalytic converter-to-engine bracket bolts | 47 | 35 | - | ||
| Catalytic converter-to-exhaust flexible pipe nuts | 47 | 35 | - | ||
| Catalytic converter-to-muffler and tailpipe nuts | 47 | 35 | - | ||
| Engine lifting eyelet bolt | 45 | 33 | - | ||
| Evaporative Emission (EVAP) canister purge valve bracket bolts | 6 | - | 53 | ||
| Exhaust flexible pipe-to-muffler and tailpipe nuts | 47 | 35 | - | ||
| Heat shield bolts | 11 | - | 97 | ||
| Roll restrictor bolt | 70 | 52 | - | ||
| Service clamp nuts | 47 | 35 | - | ||
| Worm gear clamp | 7 | - | 62 | ||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.