Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS SES, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 877 (FRONT SUSPENSION)REMOVAL AND INSTALLATIONFRONT SUSPENSION - EXPLODED VIEW
2010 Ford Focus SES, 2D Coupe, Standard
Front Suspension - Exploded View
2010 Ford Focus SES, 2D Coupe, StandardSECTION Front Suspension - Exploded View
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | W705967 | Wheel hub nut |
| 2 | - | Cotter pin |
| 3 | W705833 | Tie-rod end-to-knuckle nut |
| 4 | W520213 | Lower ball joint pinch bolt nut |
| 5 | W709618 | Lower ball joint pinch bolt |
| 6 | W711999 | Strut-to-knuckle nuts (2 required) |
| 7 | W711998 | Strut-to-knuckle bolts (2 required) |
| 8 | 3K171 LH/ 3K170 RH | Wheel knuckle |
| 9 | W500749 | Front lower arm bolt |
| 10 | W708549 | Rear lower arm bolt |
| 11 | 3A424 LH/ 3A423 RH | Lower arm |
| Item | Part Number | Description |
|---|---|---|
| 1 | W708990 | Stabilizer bar link nuts (upper) (2 required) |
| 2 | W708990 | Stabilizer bar link nuts (lower) (2 required) |
| 3 | 5K483 | Stabilizer bar links (2 required) |
| 4 | W506441 | Stabilizer bar bushing bracket bolts (4 required) |
| 5 | 5486 | Stabilizer bar bushing bracket (2 required) |
| 6 | 5484 | Stabilizer bar bushings (2 required) |
| 7 | 5494 | Stabilizer bar |
- For additional information, refer to the following procedures.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.