Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS SES, 2D COUPE, STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE MECHANICAL - 2.0LIN-VEHICLE REPAIRVALVE SEALSINSTALLATION
2010 Ford Focus SES, 2D Coupe, Standard
Valve Seals: Installation
2010 Ford Focus SES, 2D Coupe, StandardSECTION Installation
- Install the valve stem seal installation sleeve.
- Using the Valve Stem Oil Seal Installer, install the valve seal.
-
NOTE: Check the seating of the valve collet.
Using the Valve Spring Compressors, install the valve spring.
- Insert the valve spring and the valve spring retainer.
- Compress the valve spring and install the valve collet using some multi-purpose grease and a small screwdriver.
- Disconnect the compressed air supply.
- Repeat the appropriate removal and installation steps for all of the other cylinders.
- Install the spark plugs. For additional information, refer to ENGINE IGNITION - 2.0L .
- Coat the valve tappets with clean engine oil and insert them.
- Install the camshafts. For additional information, refer to CAMSHAFTS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.