Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS SES, 2D COUPE, STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE MECHANICAL - 2.0LGENERAL PROCEDURESVALVE CLEARANCE CHECK
2010 Ford Focus SES, 2D Coupe, Standard
Valve Clearance Check
2010 Ford Focus SES, 2D Coupe, StandardSECTION Valve Clearance Check
- Remove the valve cover. For additional information, refer to VALVE COVER .
- Remove the 2 bolts and accessory drive belt splash shield.
- To install, tighten to 9 Nm (80 lb-in).
-
NOTE: Turn the engine clockwise only, and use the crankshaft bolt only.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.